SEG EBM Overunity Generator by CCRES


SEG EBM Overunity Generator

This animation shows the device operating with the magnetic fields visible. I am uncertain if this is truly an accurate representation of the size and alignment of the fields but i believe it to be a relatively close estimation.

This is an illustrative render of the “Searl-effect” Generator. If you happen to be a scientist who can instruct me on how to make this demo more accurate any input would be appreciated. Also, any apparent clockwise rotation is an optical illusion caused by the rendering technique. All rotation seen here is counter clockwise.More info at

Upgraded demonstration of the Searl effect. 0 volts to 1.5 volts to 0 volts. 200rpm (double speed).More info at

A demonstration of twelve rollers rotating around the centre ring of the SEG Free Energy Device designed by Professor John Searl.More info at

More info at

More info at

John Searl’s Inverse Gravity Vehicle



CROATIAN CENTER of RENEWABLE ENERGY SOURCES (CCRES)• was founded in 1988 as the non-profit European Association for Renewable Energy that conducts its work independently of political parties, institutions, commercial enterprises and interest groups, • is dedicated to the cause of completely substituting for nuclear and fossil energy through renewable energy, • regards solar energy supply as essential to preserve the natural resources and a prerequisite for a sustainable economy,• acts to change conventional political priorities and common infrastructures in favor of renewable energy, from the local to the international level, • brings together expertise from the fields of politics, economy, science, and culture to promote the entry of solar energy, • provides the opportunity to play a part in the sociocultural movement for renewable energy by joining the association for everyone, • considers full renewable energy supply a momentous and visionary goal - the challenge of the century to humanity. Zeljko Serdar Head of CCRES association

2 Responses to SEG EBM Overunity Generator by CCRES

  1. “When a distinguished but elderly scientist states that

    something is possible, he is almost certainly right.

    When he states that something is impossible,

    he is very probably wrong.”

    Arthur C. Clarke (1917 – 2008), Clarke’s first law

    Searl Effect Generator (SEG)

    This slow motion animation depicts the SEG fully assembled & operating.

    The Searl Effect Generator (SEG) functions along the principles of a linear induction motor (LIM), but designed around a circular track for continuous motion of movable rotors. It is a magnetic prime mover of electromagnetic multi-phased cylindrical rollers over fixed stator rings and free of any mechanical wear or friction.

    The SEG’s stators and rollers are magnetic components uniquely magnetized or imprinted with matching magnetic pole patterns.

    While the neodymium layer serves as a source or reservoir of electron charges that are drawn out by electromagnetic induction that form redial currents and it provides the rollers with the magneto-motive forces for rapid motion at right angles to both the electric and magnetic fields.

    This configuration of rollers in motion cuts through the magnetic flux with a unique cycloid pattern of motion that is superimposed over an orbit around the circumference of the stator. In this manner, each roller can also induce eddy currents of mutual induction between the copper surfaces to form a frictionless ‘magnetic bearing’ as it generates radial electrical potentials. Frictionless operation enables the SEG to operate without physical wear and thus enabling it to operate with a service expectancy of a lifetime.

    Technical Definition of a Surface Operating SEG

    A Plate cross-sectional view showing the four material component layers

    The generator consists of three stator rings (called Plates) that are composed of four distinctively different materials concentrically layered to each other and fixed to a base. Surrounding each of the Plates is rotors (called rollers) constructed with the same materials but are free to rotate around the Plates. The inner most Plate typically has 12 rollers, 22 on the second stage and 32 on the final Plate. Surrounding the outer most rollers are conventional electromagnets, which by way of magnetic induction taps energy out of the rapid passing of magnetized rollers. These inductive pickup coils are connected in various configurations to supply AC power at a variety of desired voltage and current levels to suit residential or industrial applications.

    The SEG is defined as a device constructed of 2,124 component parts that make up 3 plates and 66 roller sets. 12 of the 2,124 components make the 3 plates that act as reaction components. 2,112 components are employed to create 66 roller sets that also act as active components. Each roller set consists of 8 segments constructed from 32 components.

    Each segment cannot be less than 34 grams in weight, as the law of the squares defines that value as the lowest value suitable for the reasonable generation of electricity. Therefore the smallest roller set must weigh 272 grams, making a grand total of 2,244 grams per roller set for the smallest surface bound SEG.

    The SEG is a step up rotary transformer. In fact it’s a ‘three rotary transformers’ operational system, within the whole unit. The inner transformer output is fed in to the input of the second plate which increases the output of the second unit, which output feeds as an input to the final unit, thereby increasing its final output to a very high voltage. The output windings can be designed to step down the output to a standard 240 volts at the rate of about 15 Kilowatts for a home unit.

    From 1946 up to 1968 the Searl Effect was referred to as magnetic bubbles in motion as it was explained in John’s early newsletters. In 1968, it became clear that these magnetic bubbles contained particles in a set manner and that there was a set pattern to how many bubbles were present in the material. Because of this finding, Searl dropped the term ‘magnetic bubbles’ and replace it with the term ‘magnetic quantum material’ and released these details in a newsletter which has since been reproduced in one of Searl’s books a few years ago. A laboratory examination also agrees that somehow the material changes its state when produced in this manner.

    When the rollers are brought into close proximity to the SEG plate,

    the Searl Effect resonant magnetic field causes electrons to be drawn

    into and accelerated through the machine. This process is assisted by

    the highly electron-attracting or capturing effect of the neodymium layer.

    The unique mechanical and material arrangement of the SEG pulses the neodymium to continually release and replace the surplus electrons that provides both mechanical and electrical power.

    This SEG mockup is a recent development towards a working prototype which demonstrates many of the core principles of the SEG in motion.

  2. A Message from Professor John Searl.

    The first DVD will show much of what so many of you have never seen or even been aware of with regard to my interests that cover particular fields. It’s unlikely that you have read all of my books that now number over 70; they do cover all the broad subjects of my interests involved in this technology.

    If you think of me as just the S.E.G. and I.G.V. man, you are wrong, I am more than just that; you will become aware of this as DVD’s and CD’s are released.

    I have not written any more paper books because they cost a fortune and I never receive a penny back from them, even though I could write far more books without any problems.

    The DVD’s and CDs have cost many thousands of £’s in equipment, cameras, recorders, lenses, filters and sound equipment to meet all my needs to make good quality films. Much of this equipment is of Sony and JVC brand and it is all to raise awareness and gain the support needed.

    Hollywood has been here to cover a number of events that I have held and they too are producing a documentary about my life and my work with a full blown movie also planned. They will be arriving again soon to continue with that documentary film that was planned to be released on some time in the future, but there are delays on their part it, I guess it will be released some day. I have previously been in Hollywood also for some film sessions with that same group.

    Let’s keep in mind that when it comes to ignorance and greed, there is no combination more dangerous on this planet then these two mental states, for I have met with thousands of such cases through my life and some of them have seriously delayed getting the SEG on the market.

    I am quite aware of the those uninformed comments made by pathological skeptics and so-called experts over the years, but I hope these DVD’s and Hollywood’s efforts will exposed them to be in reality just B.S. experts of the old status quo, of out-of-date products, of yesterdays, of the past and not the people of tomorrow that determine our future, which I will present to you with these films.

    With the Searl Technology, there is a bright future waiting to be realized.

    Prof. John Roy Robert Searl

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s